PVE400M USER’S GUIDE
2.2 Installing the camera
PVE400M is bundled with 1/3" Sony Ex-View HAD CCD, Hi-
res weatherproof bullet camera. The camera comes with Fischer
Automatic Latching, Self Aligned 5 pin connector. Gently plug
and rotate the connector until it mates and push to lock. In this
position the connector is securely locked and pulling the cable
will not disconnect it. Fix the camera using a head strap or
helmet mount (optional). The camera has a mark of a top
position for easy orientation. In order to unplug the camera, pull
the bottom sleeve of the connector.
or.
2.3 Using other video/audio source
PVE400M can accept any standard video source. The optional
PVE-AV split cable has a standard RCA female connector
(Yellow) for video input. PVE400M can provide 12V/200mA
power for an external camera using a standard power jack. This
power source is protected by resettable fuse with 400mA limit, to
secure PVE400M from accidental shortage.
The standard electret microphone can be connected to the audio
jack. PVE400M will provide 1.1V DC bias for the microphone
on the same connect
See also the table in section
8.3
for the connector pin out, if the
custom cable is needed.
2.4 Powering up
Press and hold the power button (Figure 2 -1) until the
green LED
is on (Figure 2 - 5). The unit will be ready for
operation as soon as the
status LED
is lighted (Figure 2 - 6). To turn off, press and hold the power button again,
until
all
LEDs
are off. When the external power adapter is attached, the unit will turn on immediately. The
power button works only for battery. Alternatively the unit can be powered via AUX connector (see the table in
section
8.3
). This is useful if the unit operates with an external power source, for example inside a car, or while
stationary mounted.
Warning
:
Do not remove the battery, even if the unit is always working with the external power source.
Copyright © 2007 Darim Vision Co, All Rights Reserved
- 8 -
