Darex XT3000i, Operator'S Manual

Page: 14 / 59

13
·
The pawls should be seated in
the helix of the drill. If incorrect,
loosen chuck knob and repeat
step 4. The jaws are most likely
gripping the drill body too tightly
and will not allow the drill to
rotate into position.
8. Once the drill has been aligned correctly
and without releasing the slide handle,
tighten the chuck knob clockwise until the
chuck jaws grip the drill securely. Release
the slide handle and remove chuck from
alignment tube.
6. S-L-O-W-L-Y
squeeze
together the
red slide
handle until
it touches
casting. We
emphasize
slowly,
because
squeezing
the handles
too quickly
pushes the
drill too
deeply into
the chuck.
NOTE: If this happens, the drill
will not touch the wheel during the
sharpening process.
7. With the handles held together, look
through the viewing port and see if drill is
positioned correctly.
·
Drill point
should be
touching
the end of
the pusher
shaft cap.
CORRECT INCORRECT
Drill Alignment