Darex XT3000i, Operator'S Manual

Page: 10 / 59

9
The XT-3000 comes equipped with grinding wheels, a
sharpening fixture and 2 chucks, 1; 3mm – 12mm & 1;
12mm – 21mm.
1. Remove from shipping box and all packaging
material before powering up the machine. NOTE:
Due to the weight of the XT-3000, it is suggested that
the lip of the casting, located above the motor ,can be
used as a handle for lifting.
2. Located at the back and on the right side of the
XT3000 is the power receptacle. Within that
receptacle you will find a power inlet and accessory
receptacle.
3. The power inlet is located at the bottom
of the power receptacle.
Plug the power cord in to the power inlet and then in
to the power outlet source.
4. The accessory receptacle is located at the
top of the power receptacle and will allow
you to use a dust extraction system in
conjunction with the use of the XT3000.
*We highly recommend the use of a
vacuum when the machine is in use.
Darex offers a vacuum system
compatible with your XT3000. Call
Darex for more information.
•
SA12075EA - 115V
•
SA12072EA - 230V
5. Make sure the grit tray is in
place and secure.
6. Unbox the chucks.
7.
Make sure sharpening fixture is secured to base. For
more information on securing the sharpening fixture
see page 15.
8. To power on
the machine,
push the rocker
switch to the
ON position to
start the
grinding wheel
in motion.
9. To sharpen a drill follow steps in the next three
sections; Align, Sharpen and Point Splitting.
Setting up the XT3000