USB3-FRM13 User’s Manual
14
1
2
3
4
5
6
8
9
10
11
12
13
7
14
15
16
17
18
19
21
22
23
24
25
26
20
Power Lines
Power Return Lines
[Figure 2-12. PoCL Cable Pin out]
In order to use a PoCL, generally it requires a transformation of the Frame Grabber (power
supply section) or a dedicated cable. Frame Grabber conversion is divided into the power by
changing the design of the product to include a power supply "safe power" or "dedicated power".
Difference between the two, in the case of of "safe power" is to add some of the sensor circuit in
order to detect the possible PoCL camera – it does not detect the camera and cable, there is no
power supply. "Dedicated power" is always supplied a power, but use a fuse in order to supply
the equipment that do not receive support.
USB3-FRM13 supports dedicated power. It is only available if the camera supports PoCL and
uses PoCL cables. If either the camera or the cable does not support PoCL, PoCL does not work.
If you do not want to use the PoCL of the camera while using the PoCL cable, disconnect the
fuse (F1) on the board.
[Table 2. Compatibility Table]
Frame Grabber
Camera
Cable
Operability
Switchable PoCL
Frame Grabber
Conventional
Conventional
OK
PoCL
OK
PoCL
Conventional
NOK
PoCL
OK
Dedicated PoCL
Frame Grabber
Conventional
Conventional
NOK
PoCL
NOK
PoCL
Conventional
NOK
PoCL
OK
Conventional
Frame Grabber
Conventional
Conventional
OK
PoCL
OK
PoCL
Conventional
NOK
PoCL
NOK
Caution) When using a camera with PoCL applied and connecting a camera without
PoCL applied (when used at the same time), it is recommended to turn the
board power off and then on.
