PCIe-FRM11 User’s Manual (Rev 1.4)
-
30
- http://www.daqsystem.com
(2) Baud Rate Selection
The speed of the UART can be selected from 9600, 19200, 38400, 57600, and 115200 bps.
(3) „Send Data‟ button
Transmits data to the UART. After writing the data to be transferred in the editor box, press
the button
(4) „Get Data‟ button
The UART data transmitted from the camera to the PCIe-FRM11 is read.
(5) „Hex Display‟ selection
Show UART data as Hex value.
(6) Clear Data button
Clears the UART data recorded in the editor box.
(7) „UART Close‟ button
It is called when the board is used and the program is terminated.
5.1.4 Functions related to CC
(1)
„CC Configure‟ selection
The camera control signal line can be selected from CC1 ~ CC4 with Camera Option.
(CC3 and CC4 are not used at present.)
(2)
„CC_Out‟ button
CC Output the CC value of the selected bit in Configure.
1 ": output" 1 ": output" 0 "
1 ": output" 1 ": output" 0 "
bit2 (CC3 out) = reserved
bit3 (CC4 out) = reserved
(3)
„Configure Trigger‟ button
Set Trigger Delay, Width, and Blank for Trigger # 1 (CC1) and Trigger # 2 (CC2).
Delay & Width: 0 ~ 65535 Blank: 0 ~ 16777215
The total settable frequency is f = 1 / T
1 / ((65535 + 65535 + 16777215) * 15 ns) = 0.25 Hz.