Dante DNA1991YM, Operation User'S Manual

Page: 139 / 172

105
Click “Draw Target” to draw the size model of filtered target in the video image.
Step 5
It is to set the parameters of entrance and exit, please refer to the following sheet for more details.
Parameter Function
Enable OSD
Select “Enable OSD” and it will display the people number statistics of
entrance and exit in the monitoring image.
Working Period
Note:
It is to set the alarm period, it can enable alarm event only during the period
range which has been set.
1. Click “Setup” and the system will pop out the interface of “Working
Period”.
2. It is to set working period according to the following methods:
User may input time numerical value or press the left mouse button to
drag on the setup interface to set.
There are six periods to be set every day, select the check box in front
of the period, and then the period is valid.
Select week number (it selects Sunday by default, if it selects the whole
week, then it means the setup can be applied to the whole week, user
may also select the check box in front of the week number to implement
independent setting for some days).
3. Click “Save” to complete the setup of working period.
Installation
Mode
It is to select wall mount if there is an angle between device lens and
horizontal surface, select ceiling if the device lens face downward vertically.
Rule Name
It is to set the name of rule.
Direction
It is to select the direction of entrance and exit statistics; A->B or B->A, the
arrow direction always means the entrance direction.
Flowrate Alarm
It is to set the enter number, leave number, stranded number; it will trigger
alarm when it exceeds the limited number.
Record
Check it and so when alarm occurs, system will auto record.
Record Delay System can delay the record for specified time after alarm ended.
Relay out Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended.
Send Email
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.
Snapshot
Select “Snapshot” and the system will auto trigger alarm and snapshot when
alarm occurs.
Step 6
Click “Save” to complete the setup of people counting.
5.3.6.2 Report