Dangrill 88133, Instruction Manual

Page: 23 / 58

23
NO
SE
FI
GB
DE
DK
PL
ET
Stainless steel, aluminium and heatproof
paint are available in many diff erent
grades. Common to them all is that the
surroundings and use aff ect the metal in
the long term, resulting in colour changes,
peeling, etc.
Stainless steel does not mean that the metal
cannot rust, but is more an indication of
how fast the metal rusts. Rust and peeling
that occur with time due to use and being
left outside are not covered by the warranty.
WARNING! Keep children and pets at a safe
distance from the barbecue.
Position the gas hose so that it does not
come into contact with hot parts of the
barbecue and keep it straight.
Only use gas hoses approved by the
relevant national authorities. The gas hose
must be a maximum of 150 cm long and
must be fi tted with an approved regulator.
Check regularly that the gas hose is
not cracked or crumbling and replace if
necessary.
The gas bottle must be placed next to the
barbecue. It must not stand within the
actual barbecue.
The gas bottle must be changed outside at
a safe distance from naked fl ames and other
sources of ignition.
If you discover a leak, turn off the gas supply
at the regulator immediately and avoid
naked fl ames and other sources of ignition.
Wait a few minutes until the area has aired.
Carry out a leak test when you connect a
new gas bottle or if the barbecue has not
been used for a prolonged period. Do not
carry out the leak test using a naked fl ame!
See ‘Leak test’.
Turn off the gas supply using the regulator
after use.
Do not attempt to modify the barbecue,
including the regulator and the burners. Do
not try to open parts that have been sealed
at the factory.
The minimum diameter and the maximum
diameter of the pan/pot used on side
burner is 120 mm and 240 mm.
Assembly
Please refer to the illustrations
at the back of the user
instructions. It takes 2 people
to assemble the barbecue.
Before assembly, you must unpack all
parts (including those inside the fi re box
and lay them out in a clear manner. Where
appropriate, place them on the packaging
or a rug so that the barbecue and its parts
do not get scratched while you assemble
the barbecue.
Wait until the end to tighten all screws,
bolts and nuts. All the barbecue parts are
manufactured very accurately relative to fi t,
and if you tighten something slightly askew
or too tight, it can aff ect the assembly
elsewhere on the barbecue.
Use
1. Turn all the control knobs to the PUSH
position.
2. Open the lid before use.
3. Connect the regulator to the gas
bottle. Set the gas supply to ON on the
regulator. Use soapy water to check for
any gas leaks between the gas bottle
and the regulator.
4. Press the control knob for the burner on
the far left for 3-5 seconds and turn it 90
degrees anticlockwise to position CLICK.
A click will be heard, and the burner
will ignite. If unsuccessful, repeat the
procedure. Hold the knob pressed in for
a few seconds once the burner is lit.
5. If the burner still does not ignite after
the second attempt, wait 5 minutes and
repeat step 4.