3.9 Final Set-Up and Test
3.9.1 Final Set-Up and Test
To test the set-up and ensure that the adjustable frequency drive is running, follow these steps.
Step 1. Locate the motor nameplate
NOTE!
The motor is either star- (Y) or delta-connected (
Δ
). This information is located on the motor nameplate data.
Step 2. Enter the motor nameplate data in this parameter list.
To access this list, first press the [QUICK MENU] key, then select “Q2
Quick Set-up”.
1.
Motor Power [kW]
or Motor Power [HP]
par. 1-20
par. 1-21
2.
Motor Voltage
par. 1-22
3.
Motor Frequency
par. 1-23
4.
Motor Current
par. 1-24
5.
Motor Nominal Speed
par. 1-25
Step 3. Activate the Automatic Motor Adaptation (AMA)
Performing an AMA will ensure optimum performance. The AMA measures the values from the motor model equivalent diagram.
1.
Connect terminal 37 to terminal 12 (if terminal 37 is available).
2.
Connect terminal 27 to terminal 12, or set par. 5-12 to 'No function' (par. 5-12 [0])
3.
Activate the AMA par. 1-29.
4.
Choose between complete or reduced AMA. If a sine-wave filter is mounted, run only the reduced AMA, or remove the sine-wave filter during
the AMA procedure.
5.
Press the [OK] key. The display shows “Press [Hand on] to start.”
6.
Press the [Hand on] key. A progress bar indicates if the AMA is in progress.
3 How to Install
VLT
®
Automation Drive FC 300
Instruction Manual High Power
3-62
MG.33.U2.22 - VLT
®
is a registered Danfoss trademark
3