Danfoss VLT 2800, Design Manual

Page: 154 / 162

PNU # Parameter description Factory setting 4-set-up Conv. index Data type
400 Brake function Depends on unit type No 0 5
405 Reset function Manual reset Yes 0 5
406 Aut. restart time 5 s Yes 0 5
409 Trip delay overcurrent Off (61 s) Yes 0 5
411 Switching frequency 4.5 kHz Yes 0 6
412 Var. carrier frequency No LC-filter Yes 0 5
413 Overmodulation function On Yes 0 5
414 Min. feedback 0.000 Yes -3 4
415 Max. feedback 1500.000 Yes -3 4
416 Process units No unit Yes 0 5
417 Speed PID propor.ampl. 0.010 Yes -3 6
418 Speed PID intergra. 100 ms Yes -5 7
419 Speed PID differentiation time 20.00 ms Yes -5 7
420 Speed PID diff. amplification limit 5.0 Yes -1 6
421 Speed PID lowpass filter 20 ms Yes -3 6
423 U1 voltage Parameter 103 Motor voltage U
M,N
Yes -1 6
424 F1 frequency Parameter 104 Motor frequency f
M,N
Yes -1 6
425 U2 voltage Parameter 103 Motor voltage U
M,N
Yes -1 6
426 F2 frequency Parameter 104 Motor frequency f
M,N
Yes -1 6
427 U3 voltage Parameter 103 Motor voltage U
M,N
Yes -1 6
428 F3 frequency Parameter 104 Motor frequency f
M,N
Yes -1 6
437 Proc. PID no/inv. Normal Yes 0 5
438 Proc. PID anti wind. Active Yes 0 5
439 Proc. PID start frequency Parameter 201 Output frequency low
limit, f
MIN
Yes -1 6
440 Proc. PID start proportional ampl. 0.01 Yes -2 6
441 Proc. PID integration time Off (9999.99 s) Yes -2 7
442 Proc. PID differentiation time Off (0.00 s). Yes -2 6
443 Proc. PID diff. ampl. limit 5.0 Yes -1 6
444 Proc. PID lowpass filter time 0.02 s Yes -2 6
445 Flying start Not possible Yes 0 5
451 Speed PID feedforward factor 100% Yes 0 6
452 Controller range 10% Yes -1 6
456 Brake voltage reduce 0 Yes 0 5
461 Feedback conversion Linear Yes 0 5
462 Enhanced sleep mode timer Off
463 Boost setpoint 100%
464 Wakeup pressure 0
465 Minimum pump frequency 20
466 Maximum pump frequency 50
467 Minimum pump power 0 W
468 Maximum pump power 0 W
469 No flow power compensation 1.2
470 Dry run time out Off
471 Dry run interlock timer 30 min.
484 Initial ramp Off
485 Fill rate Off
486 Filled setpoint Parameter 414 Minimum feedback,
FB
LOW
Table 5.22 Factory Settings for Parameters 400-486
All about VLT 2800 Design Guide
152 Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402
5 5