Procedure
1.
Strip the motor cable, the mains cable, and the brake resistor cable. See
.
The VACON
®
100 FLOW and HVAC software do not have the dynamic braking or the brake resistor functions.
2.
Cut the grommets open to move the cables through them.
A
Do not cut the grommet openings wider than what is necessary for the used cables.
B
If the grommets fold in when putting the cable, pull the cable back to make the grommets straight.
e3
0b
h2
77
.1
0
e3
0b
h2
78
.1
0
3.
Attach the grommet and the cable so that the frame of the drive goes into the groove of the grommet.
A
With the protection rating IP54 (UL Type 12), the connection between the grommet and the cable must be tight. Pull the first
bit of the cable out of the grommet so that it stays straight.
B
If this is not possible, make the connection tight with some insulation tape or a cable tie.
Electrical Installation
Operating Guide | VACON® 100 Wall-mounted Drives
AQ298036140958en-000101 / DPD01711| 49
Danfoss A/S © 2019.05
Summary of Contents for VACON 100 industrial
Page 2: ......
