10
Functionality and features
TFX INSTALLATION AND OPERATION MANUAL
6046279-001 March 2020
Example: The device does not recognize any GNSS position
(priority 4 = magenta) and has no mobile radio connection
(priority 1 = blue). The STATUS LED lights up blue.
LEDS DURING CERTAIN OPERATING MODES
The LEDs indicate certain active operating modes
and processes.
INFORMATION
The LED statuses shown in the table are examples.
The illumination of the LEDs can deviate from this
depending on the use purpose and conditions.
Table 12: LED operating modes, status indications, and
their meaning
LED
Status
Meaning
ON STATUS
Configuration update
in progress via the
CAN interface.
ON STATUS
Device is in Logging mode,
receives configured CAN
messages (orange flash)
and transmits the logged
messages to the Data
platform (blue flash).
ON STATUS
Active data transmission in
real-time mode.
ON STATUS
Device initializing after
switching on.
ON STATUS
Configuration update in
progress via the Data
platform.
ON STATUS
Remote firmware update
in progress via the Data
platform.
ON STATUS
Device reset via slide switch
on the D-sub port (CAN1).
ON STATUS
Transmission of the GPS
position and the keep-alive
message. Display varies
depending on configured
polling interval.
3.4 Cables
3.4.1 Start cable for main plug connector
The cable CLM3 start cable 6 open, 2 dsub ,1 pw, 2 m
(contained within the Starter Kit) features the following
connectors and open individual wires:
> 1 micro timer II socket,14-pin, female
> 2 D-sub, 9-pin, female (CAN1)
> 1 power connector
Micro timer II socket (14-pin, female)
Pin
Designation
Color
Description
1
Terminal 30 / VCC
White
Power supply
(permanent positive
plus vehicle battery)
2
Factory setting 1
Brown
Input
3
Terminal 31 / ground Green
Power supply
4
Analog input 1
Yellow
I/O input
5
Analog input 2
Gray
I/O input
6
Analog input 3
Pink
I/O input
7
Digital output
Blue
I/O output
8
Terminal 15
Red
Input (ignition signal)
9
Factory setting 2
Black
Input
10
CAN2-GND
Violet
-
11
CAN2-High
Gray-pink
CAN, bidirectional
12
CAN2-Low
Red-blue
CAN, bidirectional
13
CAN1-High
White-green
CAN, bidirectional
14
CAN1-Low
Brown-green
CAN, bidirectional
Start cable for main plug connector
INFORMATION
The open end connectors are numbered on the strand ends.
CAN2 not available with the current product offering.
The polarity also applies for the following cable:
•
CLM3 start cable 6 open, 2 dsub, 1 pw, 2 m (contained
within the Starter Kit)
Individual open end wires
Designation
Color
Description
Terminal 31 / ground Green
Power supply
Analog input 1
Yellow
I/O input
Analog input 2
Gray
I/O input
Analog input 3
Pink
I/O input
Digital output
Blue
I/O output
Terminal 15
Red
Input (ignition signal)
Start cable for main plug connector, individual wires open
