8
11/2013
VIIDH102
Danfoss Heating Solutions
1.7 Installing
living connect®
1.
2.
living connect
®
must be in Installation Mode
to be fixed correctly onto the valve. This is
indicated by a large, flashing
M
in the display.
Installation Mode can be selected by pressing
for 3 seconds until
M
is displayed, then
release and press again.
Screw
living connect
®
onto the adapter and
tighten by hand (max. 5 Nm).
While slightly pressing forward, turn
living
connect
®
clockwise untill it locks, then tighten.
3.
4.
Press to fix
living connect®
.
Icons for Network Connection and Alarm are
flashing, indicating
living connect®
is ready for
connection with Danfoss Link™ CC.
1.8 Automatic adjustments
During the first night of operation
living connect®
will shut off the radiator heat and then open
again to detect the exact opening point of the valve. This will allow
living connect®
to control the
heat as efficiently as possible. If necessary, the proce dure is repeated once a night for up to a week.
You might experience the valve being warm dur ing the adjustment procedure, regardless of the
room temperature.
Intelligent Control (Forecast)
During the first week of operation
living connect
®
learns when it is necessary to start heating the
room in order to reach the correct temperature at the correct time.
The intelligent control will continuously adjust the heating time compared to seasonal tempera-
ture changes.
Using Saving Program requires that your heating system has enough heat for a short period during
heat up. If your experience problems you should contact your installer.
Installation Guide
living connect®
