- -
HLP-C
+
Inverters
⑵ During the Power Up
Danger
● Do not plug the connectors
（
CONNECTOR
）
of the inverter
when it is in the delivery of current to avoid any surge into
the main control board due to plugging, which might cause
the damage of the inverter.
● Always have the protective cover in place before delivery of
current to avoid electrical shock injury.
⑶ During the Operation
will cause malfunctions, tripping protecton and damages of
components of the inverter. Please remove them as shown in
the above diagram.
● The function of STOP switch is only valid after it is set. Its
use is different with the emergency stop switch. Be careful
when using it.
● It will affect the service life of the inverter if a contact is
connected to the front end of input of the inverter to control
its starting and stopping. Generally it is required to control
it through FOR or REV terminals. Special attention should
be paid to its use in the case of frequent starts and stops.
● Please use an independent power supply for the inverter.
Do avoid using the common power supply with an electric
welder and other equipment. Otherwise it will cause the
protection or damage of the inverter.
Danger
● Never connect or disconnect the motor set while the inverter
is in running. Otherwise it will cause overcurrent trip and
even burn up the main circuit of the inverter.
● Never remove the front cover of the inverter while the
inverter is powered on to avoid any injury of electric shock..
● Do not come close to the machine when the fault restart
function is used to avoid anything unexpected. The motor
may automatically restart after stopping running
