Danfoss FC 300, Operating Instructions Manual

Page: 6 / 100

3.3 Basic Operational Programming 26
3.4 Asynchronous Motor Setup 27
3.5 PM Motor Setup in VVC
plus
27
3.6 Automatic Motor Adaptation 28
3.7 Check Motor Rotation 29
3.8 Check Encoder Rotation 29
3.9 Local-control Test 30
3.10 System Start Up 30
4 User Interface
31
4.1 Local Control Panel 31
4.1.1 LCP Layout 31
4.1.2 Setting LCP Display Values 32
4.1.3 Display Menu Keys 32
4.1.4 Navigation Keys 33
4.1.5 Operation Keys 33
4.2 Back Up and Copying Parameter Settings
33
4.2.1 Uploading Data to the LCP 34
4.2.2 Downloading Data from the LCP 34
4.3 Restoring Default Settings
34
4.3.1 Recommended Initialisation 34
4.3.2 Manual Initialisation 34
5 About Frequency Converter Programming
35
5.1 Introduction
35
5.2 Programming Example
35
5.3 Control Terminal Programming Examples
36
5.4 International/North American Default Parameter Settings
37
5.5 Parameter Menu Structure
38
5.5.1 Main Menu Structure 39
5.6 Remote Programming with MCT 10 Set-up Software
43
6 Application Examples
44
6.1 Introduction
44
6.2 Application Examples
44
7 Status Messages
49
7.1 Status Display
49
7.2 Status Message Definitions Table
49
8 Warnings and Alarms
52
8.1 System Monitoring
52
Contents
VLT
®
AutomationDrive Operating
Instructions
2 MG33AM02 - VLT
®
is a registered Danfoss trademark