Danfoss ET4500-002, Operator'S Manual

Page: 48 / 96

5.5 Replacing the intermediate dies
Position the intermediate dies
1. Close the crimping tool until the holes (5) are visible for using
the locking bolt.
2. Switch off the machine using the main switch and secure it
against switching on unintentionally.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the intermediate dies when the machine is
deactivated.
3. Use the supplied die wrench (3) to push and hold the locking
bolt backward in the basic die (1).
4. Place the intermediate dies into the mounting hole (4) using the
retaining bolt (2).