5.3 Forming the workpiece
5.3.1 Prerequisites
Prerequisites for a correct forming process:
•
The die system and the workpiece are compatible.
•
The proper jaw system is correctly mounted in the tool.
•
The forming dimension
is set correctly, please also refer to “Set-
ting the forming dimension”, Section 5.
•
Preferably form the workpiece in the centre of the crimping die
length. Eccentric forming will result in a conical forming result
and increased lopsided wear on the die system and the bearing
plates.
5.3.2 Operation mode buttons control panel
Summary of Contents for ET4400
