The Macnaught range of twin pedestal heavy duty metal
hose reels have been designed using the highest quality,
heavy gauge materials and are fitted with purpose specific
hose and swivels. There are models available for Air, Oil,
Grease and Diesel.
3) The reel base has four 1/2" (12.7mm) drilled holes for
mounting on a suitable flat surface.
Thank you for purchasing a Macnaught Twin Pedestal heavy
duty metal hose reel.
IMPORTANT INFORMATION
Read this safety information carefully before use.
Your safety is important to us. Please read and follow all the
safety instructions listed below.
CAUTION
WALL
FLOOR
CEILING
Fig 2
Fig 1
TYPICAL MOUNTING POSITIONS
0209
1
The information contained in this instruction manual will help
ensure many years of trouble free operation.
Please take a few moments to read through this instruction
manual before installing your new metal hose reel. If you
require further assistance please contact your nearest
Macnaught distributor or Authorised Macnaught Service
Centre.
GENERAL INFORMATION
TWIN PEDESTAL METAL HOSE REEL
INSTRUCTION SHEET
Please keep these instructions in a convenient location for
future reference.
INTRODUCTION
1) Make sure the line pressure does not exceed the rated
operating pressure of your model hose reel, refer
specifications.
2) Exposure of the skin directly to pressurized air or fluid could
result in severe bodily injury.
3)Before carrying out any maintenance turn off and
disconnect the supply line to the reel and carefully release
the hose line pressure.
4) Use soap and water when checking for leaks.
INSTALLATION
1) For overhead ceiling mounting: Install reels at least 3m
(10 feet) above the floor.
4) Your reel has both angle adjustable hose roller guides.
2) You will need to purchase appropriate hardware for
mounting your new reel.
a) Loosening the bolts on either side of the roller guide
b) Adjust the guide to the required angle
c) Re- tighten the bolts
5) Using the four holes in the base, mount the reel in the
desired location. Be sure to use appropriate hardware and
tighten securely.
6) Apply Teflon tape or pipe sealant to supply line threads,
attach to reel inlet and tighten. The other end of incoming
line can now be connected to desired supply source.
Tighten stopper bolts, and unlatch the reel.
7) Apply Teflon tape or pipe sealant to outlet fitting on reel
hose, then attach to desired tool, or nozzle. Check
connection for leakage, also check hose reel for correct
operation. ( see Operation section.)
MA118
0008
To adjust the angle of the roller guides .
8) If hose stopper adjustment is required, pull hose from reel
and allow to latch at desired length. Loosen stopper bolts
and slide stopper to a position close to the hose guide.
Re-tighten stopper bolts and check operation.
