Danfoss ET4350, Operator'S Manual

Page: 36 / 72

WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the crimping dies when the machine is switched
off.
3. Use the supplied die wrench (4) to push and hold the locking
bolt backward in the basic die (3).
4. Use the retaining bolt (2) to place the crimping dies (1) in the
mounting hole (6).
5. Remove the die wrench (4) to release the pressure on the lo-
cking bolt - the crimping die is now fixed.
Always use a complete set of equal crimping dies with the same
identification and diameter. One set comprises eight crimping dies
or seven crimping dies and one matching marking die.
Removing the crimping dies
1. Completely open the crimping tool.
2. Switch off the machine at the main switch.
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the dies.
• Only replace the crimping dies when the machine is switched
off.
3. Hold the crimping die to be removed with one hand.
4. Use the other hand to push and hold the locking bolt backward
in the basic die (3) by means of the die wrench (4).
5. Remove the crimping die concerned.
6. Remove the die wrench (4) and release the pressure on the lo-
cking bolt.