Danfoss ET4350, Operator'S Manual

Page: 43 / 72

5.8 Stop
1. Complete the forming process.
2. Deposit the work piece outside the machine.
3. Disconnect the power unit from the power supply.
4. Check the machine for contamination, leaks and external da-
mage.
5. Check the crimping tool and retaining bolts for contamination,
damage and secure fitting.
6. Check the oil level.
7. Remove contamination, dust and chips using a vacuum.
Inform the fitter in case of damage or other irregularities.
5.9 Emergency stop
In case of an emergency
Actuate the battery disconnection switch immediately in the event of
an emergency. The crimping tool movement will be stopped. The
drive unit is shut down.
Restart after and emergency
WARNING!
Risk of injuries!
The battery disconnection switch was probably activated due to
the occurrence of a hazardous situation. A restart of the machine
may cause injuries if the hazardous situation has not yet been
remedied!
• Remedy the hazardous situation before a restart.
1. Remedy the cause of the emergency stop.
2. Actuate the battery disconnection switch.