Installation Instruction
Danfoss Self-limiting Heating Cables
© Danfoss | FEC | 2019.02 | 17
088L8008 / VIAMQ502
GB
Hand-over to the end user
• Instruct the end-user or the daily supervisor
in the operation and maintenance of the
heating system.
• Before every period of continuous use, check
for faults in the distribution board, thermo-
stat, and sensors.
5.1
Connecting a Thermostat
If the element is connected to a thermostat such
as a ECtemp, configure basic settings according to
the table below and as described in the thermostat
installation manual.
If applicable, adjust the temperature limit in accor-
dance with the manufacturer’s recommendations
in order to prevent damage to e.g. the floor or the
pipe.
• Note, however, that the limit must not exceed
the maximum temperature limit specified per
application (see section 4).
Thermostat
Max. load
Frost protection of roof and
gutter systems
Frost protection of pipe
systems
ECtemp 316
16 A
-7 °C < On < +3 °C
-
ECtemp 330/610
16/10 A
On < +3 °C
On < +5 °C
ECtemp 850
2 x 15A
Melting < +3°C & moisture
-
Summary of Contents for ECpipeguard 10
Page 2: ......