Installation Instruction
Danfoss Self-limiting Heating Cables
© Danfoss | FEC | 2019.02 | 11
088L8008 / VIAMQ502
GB
If the insulation resistance is not as labelled, the
element must be replaced.
• Check for short circuits by measuring be-
tween the two bus wires and the screen.
3.1
Installing Elements
The heating cables bending diameter must not be
less than 25 mm (32 mm for SLPG-18). The cable
must only be bended on the flat side.
For reduction of electricity consumption, we strong-
ly recommend that it is possible to switch off the
heating cable, i.e. by using a ECtemp thermostat.
After installation the cable insulation resistance
must be measured and recorded.
At low temperatures the heating cable can become
stiff and difficult to work with. This problem can
be solved by connecting the unreeled cable to the
mains for a brief period of time.
Summary of Contents for ECpipeguard 10
Page 2: ......