5
Installation Location
Ensure that the following applies for the installation location:
•
Enough space for installation and maintenance shall be preserved.
•
The circulating air for each unit must be more than 700 m
3
/h.
•
The air inlet and outlet should be free from obstacles and impact from strong wind.
•
The unit must be located on a stable surface without increasing noise or vibrations.
•
•
It is convenient for piping and wiring.
•
Depending on the installation location, it may cause the indoor temperature to decline and also create noise
disturbances. Take this into consideration when deciding the location.
Caution! Installing the unit in any of the following places may lead to malfunction of the unit:
•
A site containing mineral oils such as cutting lubricant.
•
Seaside areas where the air contains much salt.
•
Hot spring areas where corrosive gases exist, e.g., sulfide gas.
•
Factories where the power voltage fluctuates seriously.
•
A kitchen where oil permeates.
•
A location where strong electromagnetic waves exist.
•
A location where flammable gases or materials exist.
•
A location where acid or alkali gases evaporate.
•
Other special environments.
5.1
Installation space
The recommended space for maintenance purposes is shown in the following figures:
2
≥
600 mm
≥
600 mm
≥
600 mm
1
3
4
Figure 2.
Installation space (distance)
Position Explanation
1
Air outlet
2
Display
3
Air inlet
4
Wall
10 – Installation, Service and User Manual VMGFK202
Summary of Contents for DTW 300 SP
Page 1: ...Installation Service and User Manual DTW 300 SP VMGFK202...
Page 4: ......
Page 41: ...VMGFK202...
