Service guide
|
Disassembling and Assembling, APP 0.6-1.0
© Danfoss | DCS (im) | 2017.08
8 | 180R9092 | DKCFN.PI.013.EC5.02 | 521B0739
3. Fit the hollow bush (torpedo) to the shaft.
Wet the torpedo and replacement shaft
seal with soap. Do not use silicone
grease.
4. Slide the shaft seal over the torpedo with
the carbon seal face pointing upwards.
Be
careful not to damage the carbon seal
face on the shaft seal.
7. Push the new ceramic ring into the flange
using the plastic tool provided. Make sure
the face with the rubber seal is positioned
against the shoulder in the flange.
Wet the parts with clean (filtered) soap-
water before assembly.
6. Remove ceramic ring from the flange.
8. Position the O-ring on the seal SAE flange.
5. Using the plastic tool provided, large
diameter first, press the seal home against
the shoulder, by hand.