After the network scan has completed, any resulting count will be
seen against the
Nodes Scanned on Network
line - this reflects
the number of found nodes on the scan just completed. The
corresponding line below (
Nodes configured in database
)
reflects the current total of network nodes actually configured in
the AK-SM database.
The last group in this table refers to the following node types;
OI (Output|Input)
RO (Relay output)
SI (Sensor Input)
V02 (Variable output)
Utility Meter (WattNode, Veris, Carlo Garvazzi)
Generic (Danfoss case / pack controllers)
AK-CM (AK- Communication Modules)
Calculations
Each node (type) has a column that reflects any configured or
scanned status.
2
System configuration (Time settings / preferences)
The Time tab allows the
system time, time zone, operating hours,
daylight savings and holidays
to be configured. Double click a
line to make any changes.
The following examples can be seen for the time zone;
London (GMT) = 000
Central Europe = 100
East Coast USA = -500
The operating hours can be set that reflect your store operating
hours. Any times set in this section can then be referenced to
via a ‘Relative schedule’ . Relative schedules are found under the
‘Lighting’ and ‘HVAC’ application areas and apply a (user selecta-
ble) offset which references the operating hours schedule.
3
System configuration (Time settings / preferences)
AK-SM 850
User Guide
Lit. no.
USCO.PI.R1.E1.02 © Danfoss 07-2013
19