User Guide
|
Alarm Logger, AK-SM 800AL
© Danfoss | ADAP-KOOL® | 2018.01
4 | RS8HR102
First time setup – setup wizard
Wizard 1/3 Language
Upon first start up, the AK-SM 800AL will display a simple 3-step
wizard. The first screen will ask what language the unit should
operate in. There is no requirement to reset the AK-SM 800AL
when selecting the language, the unit will dynamically adjust per
the selection. Once the wizard is competed it will not re-appear,
if changes are required to any of the items found in the wizard
selections these can be seen under the ‘Settings’ menu (Supervisor
access required).
Wizard 2/3 Users Passwords
The second wizard screen is the Users/Password screen. Here
the commissioning Engineer may define the users name and
password. Up to 9 users in total can be assigned in the system.
The first user is by factory default the ‘Supervisor’ level, this user
has access to all configuration screens in the system. As part of
the AK-SM 800 AL setup process the commissioning Engineer may
change the factory given ‘Name’ and ‘password’ for the system
Supervisor (however, the first user slot is always reserved for the
Supervisor)
Whilst ‘Supervisor’ has full system access rights, the Daily user is
intended for store staff. With the permissions level of ‘Daily User’
this user can Acknowledge and Clear an alarm or alarms. Note,
that alarms can only be manually cleared if the original alarm has
been set to a cleared status.
The Service user can change all system settings except users/
passwords.
In the example opposite, 5 users have been set, each with a
unique name. The AK-SM 800 AL will remember the last known
user Name and pre-populate this for ease of use. If this is not the
correct user group, simply select from the drop-down list.
