Status on relay for cooling
u58
Comp1/LLSV
Status on relay for fan
u59
Fan relay
Status on relay for defrost
u60
Def. relay
Status on relay for railheat
u61
Railh. relay
Status on relay for alarm
u62
Alarm relay
Status on relay for light
u63
Light relay
Status on relay for compressor 2
u67
Comp2 relay
Readout of the actual rail heat effect in %
u85
Rail DutyC %
Readout of which thermostat used for regulation: 1= Thermostat 1,
2= Thermostat 2
u86
Ther. band
Status on input DI3 (on/1 = 230 V)
u87
DI3 status
Readout of the actual cutin value for the thermostat
u90
Cutin temp.
Readout of the actual cut out value for the thermostat
u91
Cutout temp.
Temperature measured by S7 brine sensor
u98
S7 temp.
Readout of the voltage signal on the analogue output
U44
AO_1 Volt
Forced control
If you need to force-control an output, you should set r12 to -1 (manual mode). You should then select the relevant relay function, e.g. u58. Go
to the function by pressing the middle button. Select On.
User Guide | Controller for SemiPlugin appliance, AK-CC 460
18 | BC230086440483en-000201
© Danfoss | DCS (vt) | 2019.12