W E B S T A T I O N M a n u a l P a g e 36
15.4
ELECTROMAGNETIC COMPATIBILITY
This unit conforms to the Product Specifications noted on the Declaration of Conformity.
Operation is subject to the following two conditions:
This device may not cause harmful interference
This device must accept any interference received, including interference that may cause undesired operation Operation of this
unit within significant electromagnetic fields should be avoided. Use only shielded interconnecting cables.
15.5
DECLARATION OF CONFORMITY
Name Manufacturer
: D&R Electronica b.v.
Address manufacturer
: Rijnkade 15B,
: 1382 GS Weesp
: The Netherlands
declares that this product
Name product
: webstation
Model number
: n.a.
Product options installed
: none
passed the following product specifications
Safety
: IEC 60065 (7th ed. 2001)
EMC
: EN 55013 (2001+A1)
: EN 55020 (1998)
Supplementary Information:
The product passed the specifications of the following regulations;
:
Low voltage 72 / 23 / EEC
: EMC-Directive 89 / 336 / EEC. as amended by Directive 93/68/EEC
(*)
The product is tested in a normal user environment.
15.6
PRODUCT SAFETY
This product is manufactured with the highest standards and is double checked in our quality control department for reliability in
the “HIGH VOLTAGE” section
.
15.7
CAUTION
Never remove any panels, or open this equipment. No user serviceable parts inside.
Equipment power supply must be grounded at all times. Only use this product as described in the user manual or brochure. Do
not operate this equipment in high humidity or expose it to water or other liquids. Check the AC power supply cable to assure se
-
cure contact. Have your equipment checked yearly by a qualified dealer service center. Hazardous electrical shock can be avoided
by carefully following the above rules.
Ground all equipment using the ground pin in the AC power supply cable. Never remove this pin.
Ground loops should be eliminated only by use of isolation transformers for all inputs and outputs.
Replace any blown fuse with the same type and rating only after equipment has been disconnected from AC power. If problem
persists, return equipment to qualified service technician
Always earth all your equipment by the grounding pin in your mains plug.
Hum loops should be only cured by proper wiring and isolation input/output transformers.
Replace fuses always with the same type and rating after the equipment has been turned off and unplugged.
If the fuse blows again you have an equipment failure, do not use it again and return it to your dealer for repair.
Always keep the above information in mind when using electrically powered equipment.
