W E B S T A T I O N M a n u a l P a g e 17
7.8
ON
The ON switch is used to activate the module. There are 3 colours that you can choose from in dif
-
ferent states of the ON switch.
On Active = red, green or off
On+Fader Active = red, green or off
On not active = red, green or off
7.9
FADER
Final control of the channel is the 100mm long throw N-Alps channel fader with integrated fader
start function. The channel fader sends the amount of signal from the associated channel to the
master mix buss. There is no audio going through the fader, just a DC control signal driving a stereo
VCA, so fader noise will never happen in this design.
At the right side of the fader you see a dB labelling starting at the top with no attenuation (0).
Sliding down it attenuates in steps of 5dB until it reaches a full cut off below -90dB. When you are
used to fully throw the fader in its top position when opening a channel it is advisable to set the fader
gain software setting to 0dB (factory default). If you need a little bit of “playground” for your audio, set
the software-jumper to +10dB fader gain and see the -10dB (10) position as your unity gain position.
7.10
INPUT CONNECTORS
On the back of the WEBSTATION VoIP module you find four
connectors. Two unbalanced stereo line RCA Cinch connectors
for connecting CD players, iPods, or any play-back devices as
long as they are line level equipment. The level can be set us-
ing the gain control to match most source levels. The left RCA/
Cinch connector is the right input and the right RCA/Cinch con
-
nector is the left input. The shield needs to be connected to the
ground or case of the RCA/Cinch connector.
The two unbalanced stereo line RCA Cinch connectors labelled
CLEANFEED can be used to connect the Module to the input of
an external connected Telphone Hybrid such as D&R’s Hybrid-1
or 2 or the TELCOM unit. The output of the Hybrid should be
connected to the stereo line input to return the signal from the
caller into the mixer. For adjustments follow the manual of the
Hybrid.
A cleanfeed sent signal (presented on the back of this module)
is a mix of all signals that are present in the mixer except the
signal that is processed in this
VoIP channel to avoid feedback.
In case you use a classic Telephone Hybrid to connect with your
listeners, separate telephone equipment should be used to dial
the caller and interface with the landline telephone system.
