A
·
X
·
U
·
M User Manual
Version 2.5 - 2011-01-28
AXUM from D&R - Phone: +31 294 418014 - E-Mail:
- 35 -
•
Ignore module state
When presets are recalled, it checks the module state to prevent recalling ‘onair’ signals. The
preset will wait till the module is switched off air.
If the ignore module state function is switched to yes, the presets will not check the module
state and forces the recall to be done always!
6.1.11.3 Processing
These are the programmed processing defaults for the modules. Depending on the startup settings
these processing defaults will be used at startup (programmed defaults in global configuration).
The field ‘Use at source select’ determines if the default module processing in the source configuration
is used when a source is assigned via the module source select functionality and no processing preset
is assigned in the ‘source configuration’.
The following state/value processing sections are available:
•
Digital Gain level
You can enter a default gain level for each module and determine if the default state must be
on or off.
•
Low cut frequency
You can enter a default frequency of the low cut filter and determine if the default state must
be on or off.
•
Insert
You may select a source to be your insert return for this module and determine if the default
state must be on or off.
•
Phase
Set the phase default settings (Left only, right only or both channels are phase reversed). It is
also possible to determine if the default state must be on or off.
•
Mono
Give the mono settings default values (left, right or mono-sum of left and right). It is also
possible to determine if the default state must be on or off.
•
EQ
By clicking on EQ you can set the default equalizer settings it will appear in a popup window.
The state may be used to set the EQ default on or off.
•
Dynamics
This setting is used as default, the popup shows the parameters to setup. The state may be
used to set the dynamics to be default on or off.
•
Module
Here you may set the default module level at startup, the state will be the default module
on/off state.
The ‘Ignore module state’ function makes it possible to load a processing preset even if the module is
active (fader open and module on). This may be necessary if you use presets on a ‘virtual console’.
