AIRMATE-USB manual page: 7
FADER
Final control is the 100mm channel fader, this is the actual control to mix the signals.
All channels have long throw 100mm stereo faders.
At the beginning of the fader movement you will feel an internally built in start switch that is activated when
you bring up the fader. This switch activates the start circuitry controls externally connected (via the Start
Connector on the back) devices such as CD players etc.
INPUT CONNECTORS
On the back of your AIRMATE-USB module 5 and 6 you find five connectors.
Two unbalanced stereo line Cinch connectors for connecting CD players or a play-
out system. Any line level equipment can be connected here.
The level can be set by the gain control to match every source level.
The left cinch connector is the left input and the right Cinch connector is the right
input.
The shield needs to be connected to the ground.
The USB connector is wired according to international standards and is a stereo
USB1.1 Codec (HID Interface) digital input, as well as an output.
The START switch has two active connections to be wired. The tip and ring are
shorted when the ON switch or fader switch is activated.
Once you have done this, you can start the turntable with the ON (if connected to
the START connector) switch on the back panel.
These switches quick start turntables through the remote jack by a continuous
contact action at the back of the mixer. If your turntable only needs a pulse to
start ask your dealer to modify the internal circuitry to change it into a momentary
action, so you can use it as a pulse start switch.
*NEVER CONNECT THE MAINS TO THIS REMOTE-JACK*
Connections on the START connector can only be made with a maximum of
24 Volts by 50 mA. Please contact your dealer in case of doubt.
The balanced Mic input is on XLR and can provide 48volt phantom powering.
SPECIAL AVAILABLE OPTIONS IN YOUR AIRMATE-USB MODULE
On the input PCB of your AIRMATE-USB module there are several jumpers that can be changed to enable
different configurations of the channel settings.
We advise to have this done by your local dealer if the need arises.
The following 7 jumper settings can be changed to adjust the Airmate-USB to your needs.
1
J12-13
R.I.A.A. correction amp PCB can be inserted on Jumper J12 and J13.
2
J3
Low cut filter on Mic input only By shorting all 4 pins on Jumper J3.
3
J1
48 volt phantom power via Jumper J15.
4
J6/16
Stereo Aux send pre or post selectable via Jumper J6/16 (post is default).
5
J7
Clean-Feed (CLN-FEED) jumper (J7) to select whether the audio stereo signal
(summed to mono) is send to the clean-feed bus that is available in the master section for
external Hybrids.
6
J17
Pulse/continuous Jumper J17 to change the start pulse from latching (continuously) to
pulse.
7
J5
Mic gain ( Jumper J5) can be set to amplify an extra 20dB or 40dB.
8
J28-32
USB output selection