212-0019-IQ 6
12 PIN CONNECTOR:
+12V IGNITION/ +12V SOURCE:
To be connected to a +12VDC feed from the car ignition source or other
+12V source (ex. battery) . The system will turn ON only when +12VDC is activated for PIN 1.
After turning OFF the +12V input, the system will go in countdown mode for 30 min. After that it
will turn OFF automatically.
GROUND:
To be connected to a solid chassis ground, PDU or the negative terminal of the battery.
+12VDC BATTERY:
To be connected to a +12VDC battery source, via an inline 20 A fuse
and to the
control switch box through 22 AWG RED wire from the harness.
PARK KILL:
To be connected to the park switch of the car system (ground activated)
SPEAKER:
SPEAKER:
WAIL:
To be connected to the 22 AWG Green wire from the harness.
YELP:
To be connected to the 22AWG White wire from the harness.
AIRHORN:
To be connected to the 22 AWG BLACK wire from the harness.
RJ-45 COUPLER:
Factory programming.
MIC INPUT:
To connect the microphone or microphone extension cable .
P.A VOLUME:
Use to adjust the volume for public address system. Small screw driver is needed to adjust
volume.
Note:
Curves exist on one side of the connector.
They will RESIST reverse plug-ins
,
but they will NOT PREVENT
the reverse plug-ins
.
Figure 3: 12 PIN CONNECTOR
These two lines are to be connected to a 100W, 11 Ohm impedance speaker.
