212-0019-IQ 4
ENFORCER
TM
6201-IQ:
The unit consists of the siren chassis box, the switch controller and the harness (standard 18’ long). The long
harness gives the flexibility in choosing the place where the siren will be installed.
The siren can be mounted under the dash, on the transmission hump on the floor, or in the trunk. When in-
stalling the unit on the transmission hump, BE CAREFUL. Using long screws or drilling deep can cause
damage to the transmission. This unit can also be mounted in a console using a face plate.
The switch controller chassis is small and compact and can be easily mounted under the dash or other out of
sight places.
WIRING & ADJUSTMENTS
:
While wiring the siren, refer to the Wiring Diagram on page 5 for proper installation and operation of the sys-
tem.
The harness has the switch controller and the plug factory installed, which will connect with the siren socket.
If, by any reason, the plug is removed from the harness, to properly rewire the plug, strip away approximately
1/4” of insulation off the wire. Insert the wire in the proper hole and tighten the set screw. Ensure that no
strands of wire are sticking out of the hole, and that not too much insulation has been stripped away leaving
bare wire exposed. This can otherwise result in possible shorting of the system.
DANGEROUS !
Do NOT attempt to operate or test the system before ensuring a SECURE GROUND AND
POWER CONNECTION USING A DEDICATED SET OF WIRES FROM THE
BATTERY TO THE SYSTEM.
Manufacturer’s recommendations of wire size and tight connections will provide a longer
operating life for components.
Route wiring using grommets and sealant when passing through compartment walls.
Looms, grommets, cable ties and similar installation hardware should be used to anchor and
protect wiring and devices.
Particular attention should be paid to the location and method of electrical connection and
splices to protect these points from corrosion and loss of conductivity.
Ground termination should ONLY be made to substantial chassis components; preferably the
battery.
The user should install a circuit breaker in the supply line to protect against short circuits;
preferably one with a 20 Amp rating.
WARNING
