51
Fahrzeug-/Funktionsdecoder
ab Firmware-Version 1.11
51
Locomotive/Vehicle function decoder
from firmware version 3.12
The vehicle function decoder correspond functionally completely with the decoders described in point 5. Only features
in direct connection with the engine control are missing. This fact is marked in the setting options of the corresponding
system format. See:
- Point 7.2
- Point 8.2: CV09, CV49, CV50, CV51/Bit 0, CV56 – CV59, CV112
- Point 10.2: par017, par032, par052 – par054, par056 – par059
6.2 Installation of the vehicle function decoder
See notice in point 5.2.
6.3 Connection of the vehicle function decoder
Wired variants:
1 The FH05B-
0
decoder should only be used by experienced model railroaders, as the connecting wires must be soldered
directly onto the decoder.
2 In case your model is equipped with an interface according to NEM 651, you should take the decoder FH05B-
1
. It has
already the appropriate connections for this plug. Short the ribbon cable up to 5 mm and remove the rest of insulation.
The decoder can be inserted into the interface without any problem now.
3 In case your model is not equipped with an interface jack, the decoder must be wired individually. For this purpose you
should use the decoder FH05B-
3
with flexible wires.
Variants with interfaces:
4 In case your model is equipped with a 16 pin interface (PluX16), you should take the decoder FH16A-
4
. It has already the
appropriate connection for this plug. The decoder can be inserted into the interface without any problem now.
Summary of Contents for FH16A
Page 105: ...105 Notes...
