D&H DHP160, Manual, Page: 8 / 36

8
6.3 Installation
There are two variants to connect the decoder:
1 In case your locomotive is equipped with an interface (NEM 651), you should take the decoder
DHP 161 . They have already the appropriate connections for this plug. Shorten the ribbon cable up to
approximately 5 mm and remove the rest of the insulation. The decoder can be inserted into the
interface without any problem now.
2 In case your locomotive is equipped with an interface (NEM 652), you should take the decoder
DHP 252 . They have already the appropriate connections for this plug. The decoder can be inserted
into the interface without any problem now.
3 In case your locomotive is equipped with a 21-pin interface, you should take the decoder DHP
260 .
They have already the appropriate connections for this plug. The decoder can be inserted into the
interface without any problem now.
4 If the locomotive is not equipped with an interface jack, the decoder must be wired up individually. For
this purpose you should use decoder with flexible wires (DHP 163 respectively DHP 253 ).
5 The decoder DHP
160 respectively DHP 250 should be used by experienced model railroaders only as
the connection wires must be soldered directly onto the decoder.