With this kit you will transform the traditional stabilising legs of your caravan into a electrically remote operation. The actuator turn the
existing spindle with enough power for lowering and lifting the legs. The system
are not
intented to lift or adjust leveling the caranvan.
This must be performed prior lowering the stabiliser legs.
Maintenance
The system do not require any maintenance but the function depends of perfect conditions of your stabiliser legs. Turning the spindle
must be easy able to run freely, and light. Rust, dirt, non greased spindels, screwed or deformed spindels will cause an unintended
functionallity. At least ones a year inspect and maintain all moving parts of the original stabiliser legs. Use only light running PTFE oil.
The battery inside the remote must be removed if system is not in use for a longer periode.
The battery have a life time of about 2 years.
Turning on the remote
please press and hold the button «ON» more than 3 sec. Successfully turning ON the remote is indicated
by flashing green, all 4 LED´s. System is now in «automatic» mode. (default).
Note:
If the remote are unable to see the receiver in the caravan, it will warn with red flash on LED «A» in 10 sec. Check caravan power!
With remote in
Automatic mode
Shortly activating the button «down», the legs starts to lower one by one. The sequence starts with R rear, Left rear, R front and
finally L front. Every leg stops automatically when touch down force is reached. After all legs are down, the system perform a extra turn
on each legs to ensure full contact to the surface.
When activating shortly the button «UP», the legs starts one by one to lift. After legs are in top possition, they perform a
loosen-operation by turning half turn down. This ensure the leggs not to block, if not used for a longer periode.
Manual operation of legs individually
You are able to provide extra power to each of the individually leg. When remote is in «automatic» mode, you can press shortly
the «ON» button to chose a leg individually. Each pres on the «ON» button will change to anoter leg. The chosen leg are flashing
green, and you can operate by UP or DOWN bottons as you like.
Normally it is not recommanded to provide this extra power. To much load can damage the caravan construction.
Interruption
of automatic function will always be possible by simply pressing one of the buttons of the remote shortly. Turn off the main
power (caravan main power switch) will also to stop the function.
Turning off the remote
The remote turn off automatically after 5 minutes if it is not used. (sleep function)
Site 2/8
Copyright: www.dancar.dk
How to use
Warning
Activating the system must be done with greatest attention and it must be ensured that
no
objects, body parts or animals are nearby the
the satbiliser legs when in motion.
Do not touch the stabiliser legs itself, or nearby when system in powered. Do always turn of the power to the system when not in use.
Important
The system power must always be turned off when towing the caravan. Always check by visual control that the satbiliser legs are in
desired position prior towing the caravan.
!
ON button
DOWN button
UP button
Led «A»
