OUTSIDE TOP EXHAUST
Use these instructions if the
appliance will be vented to the
outside through the top of the
appliance.
Install the mounting plate
Use a 5/8” drill to make two holes
that will enter the drywall. Use a
3/16” drill to make a hole that will
enter a wall stud. Use the mounting
template to decide the location of
the holes. At least one hole must
enter a wall stud.
Insert the machine screws into the
mounting plate through the holes
designed to go into drywall and
attach the wing nuts 3/4” onto
each machine screw.
Place the mounting plate against
the wall and insert the wing nuts
into the holes in the wall. The wing
nuts will open on the other side of
the wall to secure the screw.
Do not place a wing nut on the
screw that will go into the wall stud.
Insert a wood screw through the
mounting plate and into the wall
stud. Tighten all screws.
ϱШϴΗ
INSTALLATION INSTRUCTIONS
Using the top cabinet template
There are instructions on the top
cabinet template that detail how it
should be used.
Tape the top cabinet template to the
under side of the cabinet where the
microwave will be installed.
Drill holes for the top support
screws, a hole large enough for
the power cord to fi t through and a
cutout large enough for the exhaust
adapter.
Check for proper damper
operation
Place the microwave in its upright
position with the top of the
appliance facing up.
Make sure the tape securing
the damper is removed and the
damper pivots easily before
mounting the microwave.
Attach the exhaust adapter to the
blower plate by sliding it into the
guides. Secure the adapter with
one sheet metal screw.
13
