Dugan Model E-2 User Guide
22
Linking
Up to eight Dugan units can be linked into a single automatic mixing system. The
audio I/O for each must be configured and connected individually. Linking passes
only control information between Dugans, not audio.
One unit must be set to be the master and the others slaves.
1.
Designate one unit as the master by setting the
NORM–SLAVE
switch on the rear
panel to
NORM
(up).
2.
Designate any other units as slaves by setting their
NORM–SLAVE
switches on the
rear panel to
SLAVE
(down).
3.
Use ADAT (Toslink) cables to link units in a ring network (see above).
Note that all
LINK IN
and
OUT
connectors are used to create the ring.
Figure 3-3
Linking Dugan units
Patching the Model E-2 as an Insert to your Console
The best place to insert the
•
Dugan Speech System channels is post-EQ, post-fader, pre-compressor;
•
Dugan Music System channels is post-EQ, pre-fader, pre-compressor.
Unprocessed Outputs
When using the
ANA
setting, the ADAT
AUD OUT
connector can send unprocessed sig-
nals (channels 1–8) to a multitrack recorder.
When using the
DIGI
setting, the
AUDIO I/O 1–4
and
AUDIO I/O 5–8
connectors can send
unprocessed signals (channels 1–8) to a multitrack recorder.
Summary of Contents for E-2
