Dan Dugan Sound Design Dugan-MY16, User Manual

Page: 3 / 44

FCC
1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT! This product, when in-
stalled as indicated in the instructions contained in this manual, meets FCC re-
quirements. Modifications not expressly approved by Dan Dugan Sound Design
may void your authority, granted by the FCC, to use the product.
2. IMPORTANT : When connecting this product to accessories and/or another
product use only high quality shielded cables. Failure to follow instructions could
void your FCC authorization to use this product in the USA.
3. NOTE : This product has been tested and found to comply with the requirements
listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of this
product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if
not installed and used according to the instructions found in the users manual,
may cause interference harmful to the operation of other electronic devices.
Compliance with FCC regulations does not guarantee that interference will not
occur in all installations.
If this product is found to be the source of interference, which can be determined
by turning the host unit OFF and ON, please try to eliminate the problem by using
one of the following measures: Relocate either this product or the device that is be-
ing affected by the interference. Utilize power outlets that are on different branch
(circuit breaker or fuse) circuits or install AC line filter/ s. In the case of radio or
TV interference, relocate/ reorient the antenna. If the antenna lead-in is 300 ohm
ribbon lead, change the lead-in to co-axial type cable. If these corrective measures
do not produce satisfactory results, please contact the local retailer authorized to
distribute this type of product. If you can not locate the appropriate retailer, please
contact Dan Dugan Sound Design.
The above statements apply ONLY to those products manufactured by Dan Dugan
Sound Design.
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful interference.
- AND -
2. This device must accept any interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.