22
User Manual, Rev 02
Rad-icon 2329 GigE Detector
Teledyne DALSA
Connecting
1.
After the installation is complete, plug in the detector’s communication cable.
2.
Power up the detector.
3.
After powering up the detector, the application automatically detects the detector.
This may take 30 to 65 seconds. Wait until the detector connected indicator in the
task bar (shown below) has confirmed that a connection has been established (the
red cross over the camera icon disappears).
Checking detector status and information in Gigabit Ethernet
After the detector connection has been established, the status of the connection can be
displayed by right clicking on the camera icon in the task bar and selecting “SHOW
Status Dialog Box.”
When you add or remove a detector from the network, it is automatically detected by
the GigE server. A manual network scan can also be launched from this menu by
selecting “Scan Network.” This action will refresh the information of the device
connected to the network. The “About Sapera GigE Server” option will display the
version of the installed GigE driver.
Selecting the “SHOW Status Dialog Box” will open the device status window, which
displays the basic information of the detector:
-
Serial Number
-
Model Name
-
MAC Address
-
Packet size, which should be 9000
-
Firmware version which only indicates a build number
Refer to the “DeviceVersion” to see the actual firmware version (this can be
seen in CamExpert)
-
IP addresses of
o
Detector
o
Network Interface Card on host system to which the detector is
connected
These settings can be changed by the Network Configuration which is included in the
GigE Vision framework
The user can also view the detector and the host system IP addresses in this window.
