Dalsa Piranha XL PX-HM-16K12B-00-R, User Manual

Page: 58 / 66

56
•
The Piranha XL Camera
What each flag signifies:
BIST Error Description Status Code (Bit Set) Potential Cause
SUCCESS 0x00000000 No errors detected
I2C Error 0x00000001 Camera internal hardware
FPGA_NO_INIT 0x00000002 Camera internal hardware
FPGA_NO_DONE 0x00000004 Camera internal hardware
EXT_SRAM ERROR 0x00000008 Camera internal hardware
ECHO_BACK ERROR 0x00000010 Camera internal hardware
FLASH_TIMEOUT 0x00000020 Camera internal hardware
FLASH_ERROR 0x00000040 Camera internal hardware
NO_FPGA_CODE 0x00000080 Camera internal hardware
NO_COMMON_SETTINGS 0x00000100 Camera internal hardware
NO_FACTORY_SETTINGS 0x00000200 Camera internal hardware
OVER_TEMPERATURE 0x00000400 The camera has detected excessive internal temperatures
and has partially shut down for protection. Remove power
to recover and improve airflow over the camera fins
(reserved) 0x00000800 -
NO_USER_FPN 0x00001000 The user has yet to save any FPN calibration data to a
User Set. (Note. Default values should have been set by
the factory)
NO_USER_PRNU 0x00002000 The user has yet to save any PRNU calibration data to a
User Set. (Note. Default values should have been set by
the factory)
CLHS_TXRDY_RETRY 0x00004000 The camera cannot establish CLHS communications with
the frame grabber. Check the CLHS connection integrity.
INVALID_UPGRADE 0x00008000 An invalid file format or type was used when trying to
upgrade software or coefficients.
NO_USER_SETTINGS 0x00010000 The User has yet to save a User Set (Note. Default values
should have been set by the factory)
NO_ADC_COEFFICIENTS 0x00020000 Camera internal hardware
NO_SCRIPT 0x00040000 Camera internal hardware
Status LED
A single red/green LED is located on the back of the camera to indicate status.
LED State Description
Off Camera not power up or waiting for the software to start
Constant Red The camera BIST status is not good. See BIST status for diagnosis.
Blinking Red The camera has shut down due to an over temperature condition.
Blinking Orange Powering Up. The microprocessor is loading code.
Blinking Green Hardware is good, but the CLHS connection has not been established or has recently
been broken.
Constant Green The CLHS Link has been established and data transfer may begin