dallmeier DDF4010HDV, Installation And Configuration Manual

Page: 25 / 107

DDF4010HDV
www.dallmeier.com 25

Carefully insert the plug-in module into the housing base until it clicks into place.
The number of the spring clips must match the number of the slots.

Secure the plug-in module.
For this purpose, tighten the 2 securing screws of both spring clips ( Fig. 5-7 ).
Housing base
Slot for spring clip 1
Securing screw
(spring clip 2)
Plug-in module
Spring clip 2
Securing screw
(spring clip 2)
Slot for spring clip 2
Fig. 6-7

If PoE (Power over Ethernet) is not available, first connect the camera to a suitable
power supply unit and then connect the power supply unit to the mains socket.

If necessary, connect a CVBS monitor to the video preview output ( Fig. 5-7 ).

Align the camera with your scene using the 3-axis mount and set the focal length with
the TELE / WIDE buttons ( Fig. 5-8 ).
The “Little Man” symbol on the lens side indicates the sensor direction.

Disconnect the CVBS monitor from the video preview output.

Attach the housing to the housing base and tighten the 3 housing screws using a
T20 torx wrench.