Daktronics DVX-1200 Series, Installation & Service Manual, Page: 9 / 10

DVX-1200/2200/2210 Series Panel Installation & Service Quick Guide Page 9 of 10
DD5166395
Rev 05
20 October 2023 201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Prolink Solution
Install PLR
Prolink devices will be provided when choosing DVX-2210 Series.
The power box hook lock is different from the quick latch on DVX-
1200/2200. Refer to Figure 60.
Devices and tools Needed.
• PLR
• PLR Support
• Fasteners (M4x12 Countersunk Phillip head screw + M4 nut)
• Self-drilling screw (M4x10)
• Optical Fiber cable (Customer provided). The length and type are
according to the project’s configuration.
• Power cable for PLR (Daktronics provided)
• Signal cable (Daktronics provided). Female or Male end type to be
selected on site, refer to site-specific riser drawings requirements.
Refer to Figure 82.
Figure 82: Devices and Tools
PLR
PLR Support
Screws and Nut
Optical Fiber cable
Power cable for PLR
Signal cable
Follow these steps to install a PLR.
1. Remove the backsheet. Refer to Figure 38 , Figure 39 , Figure 40 and
Figure 41 .
2. Find the pre-drilled holes on the bottom of the horizontal stiffener
underneath the power box. There are several holes on the stiffeners to
be chosen as the PLR mounting location. Refer to Figure 83.
Figure 83: Pre-Drilled Holes
3. Install the pre-assembly devices of the PLR on the stiffener using the M3
self-drilling screws. Refer to Figure 84.
Figure 84: Install PLR
Reverse these steps to remove the PLR.
Power Cable Installation
1. Locate the closed power box. Refer to Figure 85.
Figure 85: Closed Power Box
2. Plug in the PLR power cable connector, and make sure the gland nut is
tightened. Refer to Figure 86.
Figure 86: Plug In the PLR Power Cable Connector
3. Plug in the PLR power cable end to the PLR board, and make sure the
connector is locked with the hook. Refer to Figure 87.
Figure 87: Plug in the PLR Power Cable End
4. Connect the incoming cable to the fiber cable connector of the PLR
board, and make sure the connector is locked with the hook. Refer to
Figure 88.
Figure 88: Fiber cable Installation