Daktronics DVX-1200 Series, Installation & Service Manual, Page: 4 / 10

DVX-1200/2200/2210 Series Panel Installation & Service Quick Guide Page 4 of 10
DD5166395
Rev 05
20 October 2023 201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Service
Note: Avoid exposing the contents of the power/signal box to moisture,
as the components are not sealed for water exposure.
Module
Front-Access Module Removal
To remove a module from a front-access display, follow these steps:
1. Disconnect power to the display.
2. Insert the module removal tool into the keyhole on the front of the
display and turn counterclockwise. Refer to Figure 32 and Figure 33 .
Figure 32: Front Keyhole Position
Figure 33: Use Module Removal Tool
3. Pull the module away from the panel. Refer to Figure 34 .
Figure 34: Pull the Module Away
4. Unlock the connector from the rear of the module after the module is
removed. Push lock up to open. Refer to Figure 35 .
5. Remove the connector from the rear of the module. Refer to Figure 36 .
Figure 35: Remove Both Connector
Locks
6. Before reconnecting the modules, check the module map in the
power-signal box to ensure proper connections. Refer to Figure 37 .
Figure 37: Module Map
Reverse these steps to install a module in a front-access display.
Rear-Access Module Removal
Note: To access modules in the extremities of a given section, adjacent
inner modules (Middle Left, Middle Center, or Middle Right in
Figure 49 ) may need to be removed.
To remove a module from a rear-access display, follow these steps:
1. Disconnect power to the display.
Figure 36: Remove Connector
2. Remove the screws from the backsheet and lift the backsheet up and
away from the display. Refer to Figure 38 , Figure 39, Figure 40 , and
Figure 41 .
Figure 38: Backsheet Screw
Locations
Figure 40: Lift Backsheet Up Figure 41: Pull Backsheet Out
3. Disconnect the fan cables. Refer to Figure 42.
Figure 42: Disconnect Fan Cable
Figure 39: Remove Screws from
Backsheet