Daktronics DVX-1200 Series, Installation & Service Manual, Page: 6 / 10

DVX-1200/2200/2210 Series Panel Installation & Service Quick Guide Page 6 of 10
DD5166395
Rev 05
20 October 2023 201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
DVX-2210 Series with Structure Blocking Rear Side
The power box opening solution can be used for the DVX-2210 Series.
The power box of DVX-2210 can be accessed from the front or rear, the
same as DVX-1200/2200. Refer to Power/Signal Box (p.5) .
Depending on site conditions, the door of the DVX-2210 power box can be
removed when some structure blocks the rear side of the panel. Refer to
Figure 58 to understand the scenario.
Figure 58: DVX-2210 with Structure Blocking Rear Side
Open the power box from the rear by following these steps:
1. Disconnect power to the display.
2. Remove the backsheet. Refer to Figure 38 , Figure 39 , Figure 40 and
Figure 41 .
3. Find the hinge stopper on the bottom of the power box and loosen the
screw. Push in the stopper to set the hinge free. Refer to Figure 59.
Figure 59: Set the Hinge Free
4. Unlock the hook lock of the power box. Refer to Figure 60.
Figure 60: Unlock the Hook Lock
5. Open the door of the power box at an angle and according to the
clear distance with the structure. Slide the door to the right side to
separate the hinge. Refer to Figure 61.
Figure 61: Separate the hinge
6. Remove the cable connector to the fan. Refer to Figure 62.
Figure 62: Remove Fan Cable Connector
7. Remove the door of the power box. Access the power box for
maintenance. Refer to Figure 63.
Figure 63: Remove Power Box Door
Reverse these steps to install a power/signal box when structure blocks the
rear side of DVX-2210 panel.