5
MAN #650519C
Installation: Wiring for Standalone Speed*
Using Speed 1 or Speed 2 outputs
Connecting GPS-50-2 to:
▪
Standalone speedometer
▪
Dakota Digital dash system without BIM support
▪
Dakota Digital dash system while also using a BIM-01-2 series
Two speed outputs are offered to accommodate the type of speedometer you have.
The speed output frequency is selectable to certain fixed standards, default is 8,000 pulse per mile.
➢
See page 17 for the speed output options to select from.
All Dakota Digital gauges can use either SPEED 1 or SPEED 2.
Other brands of speedometer may only read one of the two outputs.
•
Those brands that normally ship a three-wire speed sensor, will use SPEED 1.
•
Those brands the normally ship a two-wire speed sensor, will use SPEED 2.
•
OEM speedometers tend to use SPEED 1.
OEM GM cruise controls will like the CRUISE signal when the GPS-50-
2 output is set to “
4
”, while the
CRS-2000/3000 modules from Dakota Digital need to be configured for the correct pulses, a square wave
signal by turning SW 10 on in the cruise module.
➢
See page 10 for setup options for different gauges
