Dakota GPS-50-2, Manual

Page: 15 / 20

15 MAN #650519C
Configuration Setup :

Setup: Enable Speed on BIM output -

•
Hold the switch beside the GPS-50-2 display while turning the key on.
•
The display will show the current revision code as long the switch is held.
•
Release the switch. The display will show “  ”.
•
Press and hold the switch until “  ” is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”.
•
Press and hold the switch until “  ” is displayed.
•
Release the switch. The display will show the current speed setting.
o
The default should be “  ”
•
If the setting is showing “  ”, tap the switch once to display “  ”
•
Press and hold the switch until “  “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”.
•
Tap the switch until
“  ” is displayed
•
Press and hold the switch until “ - “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”.
•
Tap the switch until “  ” is displayed.
•
Press and hold the switch until
“ - “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”, or “  ” and then blank out.
ID Number setups
Most (not all) BIM modules use a channel ID between 1 and 16 to transmit specific data to a dash control box.
Having multiple BIMs like the GPS-50-2 and BIM-19-2 (air pressure) could have a conflict with the Altimeter and
Tank pressure, as they both use channel 16. Changing the GPS-50-2 Altimeter ID to 9 or 10 will avoid any
conflicts with the five pressure channels in the BIM-19-2.
Setup: GPS clock ID number and time format -

•
Hold the switch on the GPS-50-2 module while turning the key on.
•
The display will show the current revision code as long the switch is held.
•
Release the switch. The display will show “  ”.
•
Press and hold the switch until “  ” is displayed.
•
Release the switch. The BIM display will show “  ”.
•
Tap the switch until “  ” is displayed.
•
Press and hold the switch until “  ” is displayed.
•
Release the switch. The display will show the current ID for the GPS clock.
•
Tap the switch to change the setting from

-

or
“ 
"
o
Default is
“ 
"
o
"

" will prevent the GPS clock from being displayed.
•
Press and hold the switch to save the setting. The GPS-50-
2 display will show “  ” or “  ”.
•
Release the switch. This is the current time format.
•
Tap the switch to change between 12 hour and 24 hour format.
•
Press and hold the switch until “ – “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”.
•
Tap the switch until “END” is displayed
•
Press and hold the switch until “ – “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”.
•
Tap the switch until “END is displayed.
•
Press and hold the switch until “ – “ is displayed.
•
Release the switch. The GPS-50-
2 display will show “  ”, or “  ” and then blank out.