MAN#650128
4
Saving and Setting Presets
Each button on the button panel represents a preset height. The three
user programmable heights can be changed or set as many times as desired.
Follow the steps below to set the heights.
Use Manual up and Manual down to move the motors to get to the desired
height (buttons 1 & 2 or 2 & 3).
Once at the desired height, press and hold the button that you wish to
save the current height for about 5 seconds.
The other buttons will flash indicating that the position has been saved
Release buttons and repeat the above steps for the remaining buttons
NOTE:
To move to a preset push and release a button. The motors will move
automatically to the preset height for that button. If any button is pressed while
moving to a preset height the motors will stop at the current height.
Optional Presets and Remote Manual Up/Down
The five optional remote wires coming from the controller can be used to
activate the linear motors via remote system, such as a Dakota Digital
Commander Series. The option preset wires: pink, brown, and purple represent
preset heights 1, 2, and 3 respectively. To activate a move to position the wire
needs to be momentarily grounded; this is how most outputs of remote systems
work. Check your remote system owner’s manual to insure that the outputs are
grounding.
The Manual up (white/red) and Manual down (white/black) can also be
tied to a remote system to move the linear actuators up or down. The wires are
also ground activated as long as they are grounded; connecting them to a
momentary ground will only move the motors a short distance. The Manual
up/down wires can also be connected to a momentary push button switch.
Hooking one side of a push button switch to the momentary up/down wire of the
PAC-3100 and the other side to ground will allow the linear actuators to move as
long as the push button is held. This can be use as an emergency open feature
by mounting a push button switch outside the vehicle and connecting it to the
Manual up (white/red) wire. See figure below for wiring push buttons.
WHITE w/ RED
WHITE w/ BLACK
Manual Up
Manual Down
To Controller
Momentary Push
Button Switches
To Controller
Ground to
Chassis
