MAN#650128
3
Safety Disable (SWITCH 1)
The safety disable feature will only allow the system to operate when the
key is off. For proper operation the yellow wire should be connected to a keyed
+12 V source, or ignition terminal.
Turn switch 1 ON to enable safety feature
Turn switch 1 OFF to disable safety feature
NOTE:
This safety feature will only permit the preset buttons, and remote
ground activated preset lines to work when the vehicle is off. Manual up and
down will still work since they require two buttons to be pressed and held along
with the external manual up and down wires.
Auto Move Feature (SWITCH 2)
The auto move feature will automatically open or close the linear actuators
when the key is turned ON or OFF. This feature can be used to automatically
open the trunk/cover when ever the vehicle is parked.
To enable the auto move feature turn switch 2 ON
To disable the auto move feature turn switch 2 OFF
NOTE:
When enabled the linear actuators will move to preset height 1 when
the key is turned ON, and to preset height 2 when the key is turned OFF
Auto Reverse Feature (SWITCH 3 and 4)
The auto reverse feature uses current sensing circuitry to shut the motors
off and reverses them if an over current condition is detected. The system only
senses current when the linear actuators are closing, or sensing something is
blocking the trunk/cover.
To enable the auto reverse feature switch 4 ON
To disable the auto reverse feature switch 4 OFF
Auto reverse high sensitivity turn switch 3 ON
Auto reverse low sensitivity turn switch 3 OFF
NOTE:
If the system keeps reversing when closing turn the sensitivity down,
(switch 3 OFF); if the system is still having problems closing, the auto reverse
may not be suitable for the application and you will need to shut switch 4 OFF to
disable the auto reverse feature.
Preset Buttons (Preset heights and Manual Up/Down):
There are three buttons that represent a preset height. The drawing
below shows the button numbers, button 1 is furthest from the wires that connect
the buttons to the controller. To move the motors down press and hold buttons 1
and 2 at the same time, the motors will begin moving down until the buttons are
released. Holding button 2 and 3 at the same time will move both motors up as
long as the buttons are held.
PRESET BUTTONS
3
1
2
Cable to
Controller
