MAN#650188 rev. B
6.
Insert the new LED assembly through the hole where the original bulb and connector
were. Use caution when feeding the wires through to avoid damaging the wire
insulation.
7.
Feed the wires through the round metal spacer, with one wire going through each outer
hole in the aluminum spacer. The larger diameter ring should be away from the tail
light housing. Use caution when feeding the wires through to avoid damaging the wire
insulation.
8.
Secure the metal spacer with the supplied #6 nut.
9.
Place the original lens gasket into place and replace the tail light lens. Tighten the
screws down carefully.
10.
Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the
wires from LED assembly to appropriate length once mounted, making sure wires are
routed cleanly and securely.
11.
Use the supplied moisture resistant pigtail connectors* to attach the wires from the new
LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle
harness and mating LED assembly wire into a connector and crimp following
instructions below
.
*For the best connection, soldering is recommended. But to simplify installation, the supplied connectors will
provide a fast weather resistant connection.
