[13]
MAN #650541:A
OPERATING INSTRUCTIONS
NOTE **If the cruise indicator (-) is wired, the indicator may light for up to 10 seconds upon power up. This is normal.
ON: To operate the Cruise Control, turn the power button ON. (Green LED Indicator will light, if equipped.) Wait three (3)
seconds before setting speed.
SET SPEED: To engage system, press SET/COAST or press RESUME/ACCEL and release, then remove your foot from
the accelerator pedal. Press accelerator and speed will increase, release accelerator and you will return to set speed.
COAST: Press and hold the SET/COAST button and your speed will decrease. Release button and speed of vehicle at
time button is released will be new set speed.
ACCEL: Press and hold the RESUME/ACCEL button and your speed will increase. Release button and you will have a
new higher set speed.
TAP-UP: You can gradually increase your speed by quickly pressing and releasing the RESUME/ACCEL button. Each
time you press and release the button your speed will increase by 1 MPH.
TAP-DOWN: You can gradually decrease your speed by quickly pressing and releasing the SET/COAST button. Each
time you press and release the button your speed will decrease by 1 MPH
DISENGAGE: Depress brake pedal slightly; automatic speed control will cease but set speed will stay in the system’s
memory. Also, you can disengage by pressing button to OFF position, but this erases the memory. To get the RESUME
feature to work again, you must first set a speed. Turning OFF the ignition also clears the systems memory.
RESUME: After disengaging system with brake or clutch, press RESUME/ACCEL button and release it. If acceleration
rate is faster or slower than you like, drive to within a few MPH of your set speed, then press and release the
RESUME/ACCEL button.
About Dakota Digital Cruise Control
The performance of the Cruise Control is dependent upon the condition of the engine, its size and even by the type of
emission control equipment it has. Driving at higher altitudes will have an effect on Cruise Control’s performance.
Under normal conditions and with proper switch settings, speed should be controlled within plus or minus 1 MPH. There
may be situations; however, which make it seem as if the Cruise Control is not capable of functioning accurately, such as
an extra heavy load, a very steep hill, or a severe headwind.
CAUTION: Do not use the Cruise Control on a slippery road or in heavy traffic.
CAUTION: (Manual Transmission) While driving with the Cruise Control ON, do not shift to neutral without depressing the
clutch pedal, as this may cause engine to over-rev. If this happens, depress the clutch pedal or turn OFF the main Cruise
Control Switch immediately.
OUR QUALIFIED EXPERT TECHNICAL SERVICE DEPARTMENT IS READY TO ASSIST YOU WITH ANY QUESTIONS
OR PROBLEMS THAT YOU MAY HAVE ABOUT OUR PRODUCT. CONTACT US VIA PHONE AT (605) 332-6513 (USA)
OR FAX AT (605) 339-4106 (USA).
